Strands S68 Drill Press Manual -

The S68 typically features 8 distinct spindle speeds ranging from roughly 150 RPM to 3000 RPM. Speed changes are achieved by combining the on the head with the high/low electrical switch on the motor.

The S68 is characterized by its robust gear-driven head, which allows for consistent torque across various speed settings. : Up to 20mm in mild steel.

Ensure the levers are fully detented into their marked slots. Partial engagement can cause the gears to slip under load, causing severe internal damage. Strands S68 Drill Press Manual

Never shift gears while the spindle is spinning.

Clean the internal taper with a taper wiper. Check tool shanks for damage. Worn bearings or chipped gear teeth; low oil level. The S68 typically features 8 distinct spindle speeds

Keep the vertical column rack clean of metal chips and lightly greased. ⚠️ Safety Precautions

Verify all 3 phases are active and supplying correct voltage. 6. Sourcing Replacement Parts and Technical Support : Up to 20mm in mild steel

Verify if your motor is wired for 230V 3-phase or 400V/460V 3-phase before connecting power.

Once positioned, firmly tighten the clamping handle to prevent the table from dropping or shifting under heavy drilling pressure. 4. Lubrication and Preventative Maintenance

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

The S68 is equipped with an adjustable depth gauge on the front face of the quill housing. Column drill press Strands S25 (standard) - Gnosjö Maskin