Sigmastar Sdk Install

SigmaStar SDKs are distributed as split or single compressed archives (e.g., SStar_SDK_vX.X.tar.gz ).

Once the compilation is successful, you need to flash the image to the SigmaStar device. 4.1. Creating a USB Upgrade Image Use the following commands to create a USB upgrade package: cd image ./make_usb_upgrade_sigmaster.sh Use code with caution.

This report outlines the standard procedures for installing and configuring a development environment for SigmaStar SoCs (such as the SSD20X and SSD220 series) based on official documentation from the SigmaStarDocs portal . 1. System Requirements and Host Preparation sigmastar sdk install

#!/bin/bash export SIGMASTAR_SDK_PATH=~/sigmastar_workspace/Sigmastar_SSD222_SDK export PATH=$SIGMASTAR_SDK_PATH/toolchain/arm-linux-gnueabihf/bin:$PATH export CROSS_COMPILE=arm-linux-gnueabihf- export ARCH=arm

SigmaStar uses a project-based build system. You typically need to "select" your specific hardware configuration before building. cd ~/sigmastar/sdk/project Use code with caution. Copied to clipboard SigmaStar SDKs are distributed as split or single

After a successful install and build, package the working SDK for colleagues:

Once compiled, images must be "burned" onto the chip's flash memory. Creating a USB Upgrade Image Use the following

mkdir -p ~/sigmastar_project/sdk cd ~/sigmastar_project/sdk tar -xvf sigmastar_sdk_vX.X.X.tar.gz Use code with caution.

What (SPI NAND or SPI NOR) does your board use?

Build with:

If you see command not found , you missed the ncurses-dev install. Fix with sudo apt install libncurses5-dev .