Leica Tcr805 Total Station User Manual Work !!link!! Page

Ignoring these steps results in wasted time on site and unreliable data. Let’s dive into the core components of the TCR805 that every user must master.

Aim the telescope crosshairs precisely at the center of your backsight target or prism.

If you want, I can:

This article serves as a comprehensive guide based on the TCR805 User Manual to help operators maximize the potential of this instrument, ensuring safe, efficient, and accurate work. 1. Getting Started: Unpacking and Setup

| Mode | Use Case | Prism Required? | |------|----------|------------------| | | Long range (up to 3000 m to a single prism) | Yes | | Reflectorless (RL) | Short range (up to 200 m on natural surfaces) | No | | Tracking (TRK) | Moving targets, e.g., stakeout | Yes | leica tcr805 total station user manual work

| Symptom | Likely Cause | Solution | |---------|--------------|----------| | No display | Dead battery | Charge or replace battery | | Laser pointer not visible | Class 2 laser off | Enable in Settings → Laser Pointer | | Measurement drifts | Atmospheric correction not set | Enter correct temp/pressure in [MENU] → PPM | | EDM weak in RL mode | Dirty lens or low reflectivity surface | Clean lens; use white target plate |

Turn both screws in opposite directions simultaneously to center the electronic bubble on that axis. Turn the third footscrew to level the remaining axis. Ignoring these steps results in wasted time on

Add the operator's name or notes if necessary, then press (F4). 4. Station Setup and Orientation

Once fieldwork is complete:

Select , enter a unique alphanumeric name using the keypad, and press OK (F4). Set this new job as the active job for data storage. 4. Station Setup and Orientation