Hw 130 Motor Control Shield For Arduino Datasheet Better __exclusive__

The outputs are labeled M1, M2, M3, M4.

600mA is enough for small hobby gear motors, but high-torque motors may cause the L293D to overheat and trigger thermal shutdown.

3-pin headers (GND, VCC, PWM) for 5V servos.

Comprehensive Technical Guide and Datasheet for the HW-130 Motor Control Shield for Arduino The HW-130 Motor Control Shield hw 130 motor control shield for arduino datasheet better

However, the HW-130 shield’s PCB trace width and connector ratings reduce this to:

The HW-130 Motor Control Shield is suitable for a wide range of applications, including:

// Stop analogWrite(enA, 0); analogWrite(enB, 0); delay(1000); The outputs are labeled M1, M2, M3, M4

: Used to expand control pins, meaning only a few Arduino pins are needed to control all four motor directions.

// Create motor objects AF_DCMotor motor1(1); AF_DCMotor motor2(2);

The shield stacks directly on an , Mega 2560 (partial pin usage), or Nano (with careful alignment). Below is the critical mapping: Comprehensive Technical Guide and Datasheet for the HW-130

The HW-130 Motor Control Shield typically comes with a one-year warranty and is supported by a comprehensive user manual and technical documentation. Many retailers also offer technical support and customer service to help with any questions or issues you may have.

void setup() Serial.begin(9600); // Start serial for debugging Serial.println("DC Motor Test!");